RIBBON BOW HEART WREATH

 Today  is our second day of hearts & valentines week. This project is all about ribbons & bows. An easy craft to  make & doesn't take much time at all
Supplies Needed:
What you will need is a 12''  heart shape straw wreath & I left the plastic wrap on so the straw didn't fall off.
Then I used just about 25 yards of 2 1/2'' wide  mesh ribbon which I purchased at ACMoore.
But you could use any type of ribbon you prefer.
Some thin wire for the bows & a piece of thicker wire to make a hanger
To attach the bows some u shape pins.
A small amount of lace, I used what I had laying around.
And last some self sticking felt hearts

Instructions:
First you take a piece of the thicker wire, wrap it around the center top of the heart & twist into a loop to make a hanger
To make the bows cut an 18'' length of ribbon, make your basic bow which is 2 loops. Mine was about a 2 1/2'' loop each, which would measure to a finish 5'' wide bow.
Then take some wire & wrap around the center of the bow to hold it together.
Start placing  your finish bows holding them on with the u shape pin, putting them close to each other until the whole front of the wreath is full.
Then I cut a few 4'' pieces of lace, folded them in have & tucked  a few randomly around the wreath in the middle of the bow & secured with a pin.
And lastly I put the self sticking hearts on to the bows randomly around the heart.
You are finished

I hope you enjoyed this project & maybe make one for yourself.
I would love to see what you come up with.
So until the next time have a creative & blessed craft day.
Thanks for stopping by.
Hugs, Dee